1. Excilor® FORTE Color must be applied once a day preferably after
showering. Before application clean the nail and remove any old
layers of nail varnish. Shake the bottle well before application.
2. Next, apply a uniform coating of Excilor® FORTE Color on the
whole nail surface to treat. Gently remove any excess of product
from the borders of surrounding skin. The bottle may contain cloths
of dried film residue. Wipe off any clots of dried film from the brush.
This is normal and caused by drying from air contact. It has no
influence on product performance or quality.
3. Allow the nail to dry. This takes between 3 to 5 minutes. A slightly
glossy film is formed. For optimal effect it is advisable to wait for up
to 5 minutes before putting on socks and/or shoes. After application,
a tingling sensation under the nail is normal and indicates that the
product is penetrating the nail. Excilor® FORTE Color should not be
used on healthy nails. A normal nail lacquer with the same colour
is available.
4. The formed coating is water-resistant and withstands normal
wear and friction. The coating may chip off at the edges of the nail
but this does not affect product efficacy.
5. After 24h, remove the film. You can do this by peeling off the
coating at the edge or side of the nail. Gently roll off until the
complete coating is released from the nail. You may find this
easier by using warm water. Apply new product, as instructed
above. Wash your hands well after each removal and subsequent
application. For best results, treat the complete nail for a minimum
of three months and continue the course of treatment until the nail
has recovered completely.
Make sure that the bottle is fully closed after each treatment to
prevent evaporation. At the boarder of the glass film formation may
occur

STORAGE INSTRUCTIONS

Store below 25°C.